英文名稱：

ASTM E10-14

Standard Test Method for 

Brinell Hardness of Metallic Materials

中文名稱：

ASTM E10-14

金屬材料布氏硬度的標準試驗方法

標準狀態：已作廢

替代情況：

       替代ASTM E10-12，被ASTM E10-15替代

代號說明：

This standard is issued under the fixed designation E10; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval. 

This standard has been approved for use by agencies of the U.S. Department of Defense.

標準正文

1. Scope

1.1 This test method covers the determination of the Brinell

hardness of metallic materials by the Brinell indentation

hardness principle. This standard provides the requirements for

a Brinell testing machine and the procedures for performing

Brinell hardness tests.

1.2 This standard includes additional requirements in four

annexes:

Verification of Brinell Hardness Testing Machines Annex A1

Brinell Hardness Standardizing Machines Annex A2

Standardization of Brinell Hardness Indenters Annex A3

Standardization of Brinell Hardness Test Blocks Annex A4

1.3 This standard includes nonmandatory information in an

appendix which relates to the Brinell hardness test:

Table of Brinell Hardness Numbers Appendix X1

Examples of Procedures for Determining

Brinell Hardness Uncertainty

Appendix X2

1.4 At the time the Brinell hardness test was developed, the

force levels were specified in units of kilograms-force (kgf).

Although this standard specifies the unit of force in the

International System of Units (SI) as the Newton (N), because

of the historical precedent and continued common usage of kgf

units, force values in kgf units are provided for information and

much of the discussion in this standard refers to forces in kgf

units.

1.5 This standard does not purport to address all of the

safety concerns, if any, associated with its use. It is the

responsibility of the user of this standard to establish appropriate

safety and health practices and determine the applicability

of regulatory limitations prior to use.

2. Referenced Documents

2.1 ASTM Standards:

E29 Practice for Using Significant Digits in Test Data to

Determine Conformance with Specifications

E74 Practice of Calibration of Force-Measuring Instruments

for Verifying the Force Indication of Testing Machines

E140 Hardness Conversion Tables for Metals Relationship

Among Brinell Hardness, Vickers Hardness, Rockwell

Hardness, Superficial Hardness, Knoop Hardness, Scleroscope

Hardness, and Leeb Hardness

E384 Test Method for Knoop and Vickers Hardness of

Materials

2.2 American Bearings Manufacturer Association Standard:

ABMA 10-1989 Metal Balls

2.3 ISO Standards:

ISO/IEC 17011 Conformity Assessment—General Requirements

for Accreditation Bodies Accrediting Conformity

Assessment Bodies

ISO/IEC 17025 General Requirements for the Competence

of Calibration and Testing